PolyOne Versaflex™ OM 3060-1 Thermoplastic Elastomer (TPE)

Versaflex™ OM 3060-1 is a clear, medical compliant overmold designed to adhere to multiple substrates. - Excellent bond to PC, ABS, PC/ABS, PC/PETG, and PC/PBT - Rubber Feel - Soft TouchVersaflex™ OM 3060-1 can use a variety of color concentrates. The type of color concentrates most suitable for the application are dependent upon the grade and the specific substrate materials, including color concentrate and filler levels. It should be noted that some color concentrates may affect adhesion to the substrate, resulting in decreased peel strength. Concentrates based on PVC should not be used. The final determination of color concentrate suitable should be determined by customer trials. Purge thoroughly before and after use of this product with a low flow (0.5-2.5 MFR) polyethylene or polypropylene. Versaflex™ OM 3060-1 can use regrind up to 20% with minimal property losses, provided that the regrind is free of contamination. To minimize losses during molding, the melt temperature should remain as low as possible. The final determination of regrind effectiveness should be determined by the customer. Versaflex™ OM 3060-1 has good melt stability. Maximum residence times may vary, depending on the size of the barrel. Generally, the barrel should be emptied if it is idle for periods of 8 - 10 minutes or longer. Drying is not Required Injection Speed: 1 to 5 in/sec 1st Stage - Boost Pressure: 180 to 580 psi 2nd Stage - Hold Pressure: 50% of Boost Hold Time (Thick Part): 4 to 10 sec Hold Time (Thin Part): 1 to 3 secInformation provided by PolyOne